C-SCOPE XD Bedienerhandbuch Seite 1

CS1220XD - RAPID GET YOU GOING INSTRUCTIONS Assemble and adjust for length (Twist surplus lead around stem). Insert batteries. Set the MODE S

Pre-programmed Modes There are two pre-programmed modes provided: i) Meter Audio Disc ii) Meter Disc Meter Audio Disc This is the recommended mode

Tune the detector with the search head 1-2 cm above the ground. Sweep the detector in an arc, ensuring the head is level and as close to the ground

to get maximum depth without problems associated with keeping the search head a constant height above the ground surface. When a target object has b

GENERAL HINTS Beach Mode On a wet salt beach it is best to reduce the SENSITIVITY to mid range and operate in a Discrimination Mode all the time (i.

Detection Range Your CS1220XD is a top performance detector but adverse soil conditions can significantly reduce the depth of detection. Detection

(ii) To ‘focus’ the target signal still further raise the search head, retuning if necessary, and pass the search head over the object until only

CHARGING BATTERIES A battery charge socket is provided for use with the C-Scope battery charger (see Accessories) and is located under the protectiv

against you finding it. On the other hand, if you pegged out the area scientifically and searched slowly and thoroughly, the odds of finding the rin

is well to note here that the operator should not rush. This is one of the most common mistakes made by detector users. If you rush, you will not ade

2. Respect the Country Code. Do not leave gates open when crossing fields, and do not damage crops or frighten animals. 3. Do not leave a mess. It

CONTENTS: PAGE INTRODUCTION 4 ASSEMBLY 4 BATTERIES 4 BATTERY CHECK 5 CONTROLS AND WHAT THEY DO 6 METHODS OF OPERATION 9 GENERAL HINTS 13 AC

20 TROUBLESHOOTING (a) Check the condition of batteries under load using the meter. (See Battery Check Procedure). (b) Check that the search head

Controls C-Scope CS1220XD ABCDEFG A Battery Compartment B Upper Stem & Handle Grips C Din Plug & Socket D Stem Connecting Nut E C

INTRODUCTION To protect your investment complete both sections of the enclosed guarantee card and return to C-Scope. This is particularly important

holder which is located in the battery compartment. To fit new batteries first check the power switch on the unit is switched to OFF. Then loosen th

CONTROLS AND WHAT THEY DO 1. On/Off Tune 5. Retune button 2. Sensitivity/Battery Check 6. Ground Push Select button 3.

Function Switch (3) This rotary switch selects the Pre-programmed modes Meter Audio Disc and Meter Disc or the Manual Control modes GD1 and GD2. Wh

manufacture at the optimum level. The level is the same in switch positions GD1 and GD2. Discriminate D1 & D2 The Discriminate circuit can be se

Ground (6) This push button is operative in Manual Control Modes GD1 and GD2 only. It sets the detector for operation in most types of ground condit