C-SCOPE SG-V Bedienerhandbuch PDF herunterladen (Seite 31)

Generator/ Transmitter: Searching for an Induced Signal

5. Walk in a straight line across the end line of the

Generator/ Transmitter. When a signal is detected

‘pinpoint’ that signal as shown in the ‘Using the Locator’

section. If no signal is found move the Generator/

Transmitter 5 metres and try again. Continue this

procedure moving the Generator/ Transmitter in five metre

steps, following a grid pattern, until a signal can be found.

6. It may be possible to increase the strength of the

induced signal on the buried service by improving the

positioning of the Generator/ Transmitter. Once the buried

service has been pinpointed, moving the position of the

Generator/ Transmitter from side to side will give an

increase or decrease in the Locator response. Remember,

the closer the Generator/ Transmitter is to the position of

the buried service then the stronger the signal will be on

that service.

NOTE The Generator/ Transmitter signal that the Locator is detecting will get weaker the further away

from the Generator/ Transmitter that you go. It will be necessary to regularly adjust (increase) the

sensitivity to compensate for this.

10m

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 55 56

Keine Kommentare

C-SCOPE SG-V Bedienerhandbuch Seite 31